Drive Gear 212602 For CUMMINS Engine

1. The engine tachometer does not work, the reading jumps, and the values are inaccurate
2. Gear wear and chipping, fine metallic noise in the oil pump area
3. Loss of speed signal, some electronic control systems trigger a speed fault warning

1. The gear can only be removed after taking off the external speed sensor of the fuel injection pump;
2. Check for tooth surface wear, chipped teeth, and clearance; if there is damage, replace it directly;
3. When assembling, ensure proper gear meshing alignment to avoid damaging the gear teeth.

Part Number : 212602 (REV G, 2025 HT process)

Compatibility : NT855 (400–600 hp / 298–447 kW), KTA19 (700–1,000 hp / 522–746 kW), KTA38 (1,400–2,300 hp / 1,044–1,715 kW)

Rated Torque : 1,200 N·m (885 lbft) continuous / 1,800 N·m (1,327 lbft) peak

Speed Range : 0–2,100 rpm (0–35 Hz)

Dimensions : ⌀128 mm OD × 42 mm width

Weight : 3.8 kg (8.38 lb)

Life Certification : 1,800hour (mining duty cycle equivalent)

Cleanliness : ISO 4406 16/14/12 (preassembly condition)

1. Installed on the high-pressure fuel pump housing, relying on gear meshing to transmit the shaft speed;

2. Drives the mechanical speed sensor, providing speed signals to the dashboard tachometer;

3. Belongs to the auxiliary transmission components of the fuel pump governor assembly.